FUEL PRESSURE SWITCHING VALVE > INSPECTION |
| 1. INSPECT FUEL PRESSURE SWITCHING VALVE |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - Body ground | Always | 10 MΩ or higher |
| 2 - Body ground | ||
| 1 - 2 | 20°C (68°F) | 5 to 10 Ω |
Inspect the valve operation.
![]() |
Check that air flows from port A to ports B and C.
![]() |
Apply battery voltage across the terminals as shown in the illustration.
Check that air flows from port A to port C.
If the result is not as specified, replace the valve.