Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > TERMINALS OF ECU

for Preparation Click here



CHECK INNER REAR VIEW MIRROR ASSEMBLY

E173338E05

  1. Disconnect the U12 inner rear view mirror assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    U12-1 (IG) - U12-2 (E)
    SB - W-B
    Ignition switch signal
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    U12-2 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    U12-8 (+B) - U12-2 (E)
    W - W-B
    Battery
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the U12 inner rear view mirror assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    U12-3 (REV) - U12-2 (E)
    LG - W-B
    Reverse signal
    Ignition switch ON, shift lever in R
    11 to 14 V
    Ignition switch ON, shift lever not in R
    Below 1 V
    U12-6 (CV-) - Body ground
    Shielded - Body ground
    Shielding
    Always
    Below 1 V
    U12-7 (CV+) - U12-6 (CV-)
    R - Shielded
    Display signal
    Ignition switch ON, shift lever in R
    Waveform 1
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens
    Waveform 2
    U12-14 (CB+) - U12-13 (CGND)
    B - W
    Power source
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V
    If the result is not as specified, the inner rear view mirror assembly may have a malfunction.



  5. E159949E01
  6. Using an oscilloscope, check waveform 1.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    U12-7 (CV+) - U12-6 (CV-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Ignition switch ON, shift lever in R



  7. E164781E01
  8. Using an oscilloscope, check waveform 2.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    U12-7 (CV+) - U12-6 (CV-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    Ignition switch ON, shift lever in R, screen blacked out by covering camera lens