Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The inner rear view mirror assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM


B138818E29


INSPECTION PROCEDURE

1.CHECK INNER REAR VIEW MIRROR ASSEMBLY
E168297E08
  1. Disconnect the U12 inner rear view mirror assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    U12-3 (REV) - Body ground
    Ignition switch ON, shift lever in R
    11 to 14 V
    U12-3 (REV) - Body ground
    Ignition switch ON, shift lever in not R
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR - PARK/NEUTRAL POSITION SWITCH)
E168287E05
  1. Disconnect the U12 inner rear view mirror assembly connector.

  1. Disconnect the D21 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U12-3 (REV) - D21-1 (RL)
    Always
    Below 1 Ω
    U12-3 (REV) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for A760E)
    A
    OK (for A760F)
    B
    OK (for AB60E)
    C
    OK (for AB60F)
    D
    NG
    E



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

D
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

E
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)