REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Display Signal Circuit between Inner Rear View Mirror Assembly and Television Camera Assembly |

| 1.CHECK INNER REAR VIEW MIRROR ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| U12-14 (CB+) - U12-13 (CGND) | Ignition switch ON, shift lever in R | 5.5 to 7.05 V |
|
| ||||
| OK | |
| 2.CHECK REAR TELEVISION CAMERA ASSEMBLY |

Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | U12-7 (CV+) - U12-6 (CV-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition |
|
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR - TELEVISION CAMERA) |
![]() |
Disconnect the U12 inner rear view mirror assembly connector.
Disconnect the V17 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U12-14 (CB+) - V17-4 (CB+) | Always | Below 1 Ω |
| U12-13 (CGND) - V17-3 (CGND) | Always | Below 1 Ω |
| U12-7 (CV+) - V17-2 (CV+) | Always | Below 1 Ω |
| U12-6 (CV-) - V17-1 (CV-) | Always | Below 1 Ω |
| U12-14 (CB+) - Body ground | Always | 10 kΩ or higher |
| U12-13 (CGND) - Body ground | Always | 10 kΩ or higher |
| U12-7 (CV+) - Body ground | Always | 10 kΩ or higher |
| U12-6 (CV-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||