Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

AIR SUSPENSION SYSTEM > REGISTRATION

for Preparation Click here


NOTICE:
  1. The CAN communication system must be functioning normally.
  2. Make sure that the ECM is the correct type, normally functioning and correctly installed.

HINT:
  1. If the suspension control ECU is replaced with a new one, perform registration of vehicle identification information.
  2. Vehicle identification information is obtained automatically through CAN communication when in test mode.



1. REGISTRATION OF VEHICLE IDENTIFICATION INFORMATION
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / Air suspension / Utility / Signal Check.

  1. Check that the height control MAN. indicator light in the combination meter indicates that the system has entered Test Mode.

    HINT:
    1. When vehicle identification information is stored, the height control MAN. indicator light blinks in the Test Mode pattern (0.125 seconds on and 0.125 seconds off).
    2. When vehicle identification information is not stored, the height control MAN. indicator light blinks at 1 second intervals (1 second on and 1 second off).