Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Multi-media Interface ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the multi-media interface ECU.

WIRING DIAGRAM


E180194E13


INSPECTION PROCEDURE

1.CHECK MULTI-MEDIA INTERFACE ECU


    E190399E01
  1. Disconnect the H110 multi-media interface ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H110-12 (+B) - H110-7 (GND)
    Always
    11 to 14 V
    H110-11 (ACC) - H110-7 (GND)
    Ignition switch ACC
    11 to 14 V



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - RADIO RECEIVER)


    E190393E03
  1. Disconnect the H110 multi-media interface ECU connector.

  1. Disconnect the I8 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H110-11 (ACC) - I8-11 (ACC)
    Always
    Below 1 Ω
    H110-12 (+B) - I8-12 (+B)
    Always
    Below 1 Ω
    H110-7 (GND) - I8-7 (GND)
    Always
    Below 1 Ω
    H110-11 (ACC) - Body ground
    Always
    10 kΩ or higher
    H110-12 (B+) - Body ground
    Always
    10 kΩ or higher
    H110-7 (GND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)