Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

The circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM


E146482E04


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND)


    E160626E05
  1. Disconnect the I17 and I16 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I16-2 (GND) - Body ground
    Always
    Below 1 Ω
    I16-6 (GND2) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I16-1 (+B) - I16-2 (GND)
    Always
    11 to 14 V
    I16-3 (+B2) - I16-2 (GND)
    I17-12 (ACC) - I16-2 (GND)
    Ignition switch ACC



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)