NAVIGATION SYSTEM (for DVD) > Stereo Component Tuner Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT TUNER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the I38 stereo component tuner assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I38-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I38-12 (+B) - I38-7 (GND) | Always | 11 to 14 V |
| I38-11 (ACC) - I38-7 (GND) | Ignition switch ACC | 11 to 14 V |
| I38-11 (ACC) - I38-7 (GND) | Ignition switch off | Below 1 V |
|
| ||||
| OK | ||
| ||