Home › Engine / Hybrid System ยท 1UR-FE › ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR

MANIFOLD ABSOLUTE PRESSURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR
  1. Disconnect the manifold absolute pressure sensor connector.



    A215298
  1. Remove the screw and manifold absolute pressure sensor.



    A215299
  1. Remove the O-ring from the manifold absolute pressure sensor.