Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No.1 stereo jack adapter assembly sends the sound data signal of an external device to the multi-media interface ECU through this circuit.

WIRING DIAGRAM


E193011E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER)


    E192999E02
  1. Disconnect the H114 multi-media interface ECU connector.

  1. Disconnect the H107 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H114-2 (UDI+) - H107-2 (UDO-)
    Always
    Below 1 Ω
    H114-3 (UDI-) - H107-3 (UDO+)
    Always
    Below 1 Ω
    H114-2 (UDI+) - Body ground
    Always
    10 kΩ or higher
    H114-3 (UDI-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)