Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Multi-media Interface ECU and Television Display Assembly

for Preparation Click here


DESCRIPTION

The radio receiver assembly controls the volume according to the MUTE signal from the television display assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode etc. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the radio receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM


E190161E05


INSPECTION PROCEDURE

1.CHECK TELEVISION DISPLAY ASSEMBLY


    E153728E09
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    U2-26 (MUTE) - Body ground
    Ignition switch ACC, RSE system playing → Changing source
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - MULTI-MEDIA INTERFACE ECU)


    E190380E02
  1. Disconnect the H111 multi-media interface ECU connector.

  1. Disconnect the U2 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H111-14 (MUT2) - U2-26 (MUTE)
    Always
    Below 1 Ω
    H111-14 (MUT2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)