BRAKE FLUID > BLEEDING |
| Replaced/Installed Item | Work Procedure |
| Flexible hose (front/rear) | Bleed brake line |
| Disc brake cylinder assembly (front/rear) | |
| Brake actuator assembly | Bleed brake system |
| Brake master cylinder sub-assembly | |
| Brake master cylinder reservoir assembly | |
| Brake booster assembly |
| 1. BLEED BRAKE LINE |
Bleed brake line
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.
Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the front disc brake caliper RH and LH.
After bleeding the fluid, tighten the bleeder plug and release the brake pedal.
Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the rear disc brake caliper RH and LH.
After bleeding the fluid, tighten the bleeder plug and release the brake pedal.
Check and bleed brake system.
If the following malfunction symptoms occur, air may have entered the brake fluid line. Perform the following air bleed procedures.
Check and adjust brake fluid level in reservoir (Click here).
| 2. BLEED BRAKE SYSTEM |
Bleed brake master cylinder
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold the brake pedal.
![]() |
Block the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
Bleed brake line
Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the front disc brake caliper RH and LH.
After bleeding the fluid, tighten the bleeder plug and release the brake pedal.
Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the rear disc brake caliper RH and LH.
After bleeding the fluid, tighten the bleeder plug and release the brake pedal.
Bleed VSC actuator assembly
Depress the brake pedal more than 20 times with the engine off.
Connect the Techstream to the DLC3, and turn the ignition switch on.
Select AIR BLEEDING on the Techstream.
Bleed the air out of the suction line.
Bleed the air out of the pressure reduction line.
Clear the DTCs (Click here).
Inspect for brake fluid leak.
Check and adjust brake fluid level in reservoir .
If any DTC is set, perform the troubleshooting for the DTC.
Check the DTC (Click here).