DTC P144C Open in Secondary Air Injection System Heater Control Circuit |
DTC P144D Short in Secondary Air Injection System Heater Control Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P144C | Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic). |
|
| P144D | Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic). |
|
| Related DTCs | P144C: Air pump heater relay circuit range check (Low voltage) P144D: Air pump heater relay circuit range check (High voltage) |
| Required Sensors/Components (Main) | Air pump heater relay |
| Required Sensors/Components (Related) | - |
| Frequency of operation | Continuous |
| Duration | 5 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| All of following conditions met | - |
| Battery | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Air pump heater relay | OFF |
| Air pump heater relay output terminal voltage | Low |
| Air pump heater relay | ON |
| Air pump heater relay output terminal voltage | High |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.INSPECT AIR PUMP HEATER RELAY (AI HTR) |
Inspect the air pump heater relay (AI HTR) .
|
| ||||
| OK | |
| 2.CHECK AIR PUMP HEATER RELAY (AI HTR) (POWER SOURCE) |
Remove the air pump heater relay (AI HTR).
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| AI HTR relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - AI HTR RELAY) |
Remove the air pump heater relay (AI HTR).
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| AI HTR relay terminal 2 - D56-61 (HAI1) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| AI HTR relay terminal 2 or D56-61 (HAI1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||