Home › Engine / Hybrid System ยท 3UR-FBE › ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > INITIALIZATION

for Preparation Click here



Fuel Density Learning Value Reset
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Powertrain / Engine and ECT / Utility / Fuel Density Learning Value Reset.

  5. Check that the following conditions are met.

    1. Ignition switch: ON

    2. Engine: stopped

    3. Battery voltage: 9 V or higher

  6. Press "Next".

    HINT:
    When "Next" is pressed, initialization is performed automatically.

  7. Press "Exit".