Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL BLIND SPOT MONITOR BRACKET LH
  1. Install a new grommet to the body panel.



    E230023E01
  1. Attach the 2 claws to temporarily install the blind spot monitor bracket LH to the body panel.
    Text in Illustration 
    *a
    Bolt

  1. Temporarily install the 2 bolts to the blind spot monitor bracket LH.

  1. Tighten the 2 bolts, and then tighten the screw.

    Torque:
    Bolt:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }
    Screw:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL BLIND SPOT MONITOR BRACKET RH

HINT:
Use the same procedure described for the LH side.



3. INSTALL BLIND SPOT MONITOR SENSOR LH
  1. Connect the connector.

  1. Install the blind spot monitor sensor LH with the 3 nuts.

    Torque:
    4.2 N*m{ 43 kgf*cm , 37 in.*lbf }



4. INSTALL BLIND SPOT MONITOR SENSOR RH

HINT:
Use the same procedure described for the LH side.



5. INSTALL REAR BUMPER COVER
(Click here)