Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



GENERAL
  1. The blind spot monitor system uses quasi-millimeter wave radar to detect vehicles being driven in an adjacent lane. When a vehicle enters the blind spot that is not reflected in the outside rear view mirror assembly, this system illuminates the blind spot monitor indicator on the outside rear view mirror assembly to inform the driver of the vehicle presence.
  2. While the blind spot monitor indicator on an outside rear view mirror assembly is illuminated, if the turn signal is operated, the indicator starts blinking to give additional warning to the driver.

FUNCTION OF COMPONENTS

Component
Function
Blind Spot Monitor Sensor
  1. Consists of a 24 GHz radar module and an integrated processing module.
  2. Illuminates the blind spot monitor indicator on the outside rear view mirror assembly when a vehicle is present in the blind spot area.
  3. Changes the blind spot monitor indicator on the outer rear view mirror assembly from illuminated to blinking when a turn signal is received from the combination meter assembly.
Blind Spot Monitor Indicator
Turns on or flashes based on a signal from the blind spot monitor sensor.
Blind Spot Monitor Main Switch Assembly (Warning Canceling Switch Assembly)
Turns the blind spot monitor system on or off.
Combination Meter Assembly
  1. Sends the turn signal state from the headlight dimmer switch assembly (turn signal light switch) to the blind spot monitor sensor via CAN communication.
  2. If the blind spot monitor system detects a malfunction signal while the blind spot monitor system operates, the multi-information display in the combination meter displays a warning message.
Main Body ECU (Cowl Side Junction Block LH)
Sends the destination information to the blind spot monitor sensor via CAN communication.
VSC Actuator Assembly (Skid Control ECU)
Transmits a vehicle speed signal to the blind spot monitor sensor via CAN communication.
ECM
Sends the engine speed to the blind spot monitor sensor via CAN communication.
Steering Angle Sensor
Detects the angle of the steering wheel and sends the resulting signals to the blind spot monitor sensor via CAN communication.

OPERATION DESCRIPTION
  1. Operation conditions of the blind spot monitor system

    1. The blind spot monitor main switch assembly (warning canceling switch assembly) is on.
    2. Vehicle speed is more than approximately 32 km/h (20 mph).

  2. Conditions in which a sensor can detect a vehicle
    The blind spot monitor system indicates detection of a vehicle in the detection area when either condition is met:

    1. When a vehicle is detected in an adjacent lane overtaking this vehicle.

    2. When another vehicle is detected entering the detection area because it changed lanes.



  3. Detection area


    E231426E01


    Text in Illustration 
    *a
    Within approximately 3 m (9.85 ft) behind the rear bumper
    *b
    Within approximately 1 m (3.29 ft) forward of the rear bumper
    *c
    Within approximately 3.5 m (11.49 ft) from the side of the vehicle
    -
    -

    1. Vehicles in the above areas can be detected:

      1. *: The first 0.5 m (1.64 ft) from the side of the vehicle is not included in the detection area.


OPERATION OF BLIND SPOT MONITOR INDICATOR ON OUTER REAR VIEW MIRROR ASSEMBLY


    E224408E02
  1. The blind spot monitor indicator on each outer rear view mirror assembly operates as follows:

    1. When the blind spot monitor main switch assembly (warning canceling switch assembly) is turned on, the blind spot monitor indicator on each outer rear view mirror assembly illuminates for 3 seconds (initial check).
    2. While the system is operating, when a sensor detects a vehicle in the blind spot area, the blind spot monitor indicator on the outer rear view mirror assembly illuminates.
    3. While the system is detecting a vehicle in the detection area and the indicator is illuminated, if the turn signal is turned on, the indicator starts blinking.