Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB7    Blind Spot Monitor Slave Module

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.

DTC Code
DTC Detection Condition
Trouble Area
C1AB7
The blind spot monitor sensor LH (slave) detects an internal malfunction.
Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR LH
OK

USE SIMULATION METHOD TO CHECK (Click here)