Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB8    Destination Information Undefined

for Preparation Click here


DESCRIPTION

The blind spot monitor sensor receives the destination information from the main body ECU via CAN communication. This DTC is stored when the blind spot monitor sensor cannot communicate with the main body ECU.

DTC Code
DTC Detection Condition
Trouble Area
C1AB8
The blind spot monitor sensor cannot communicate with the main body ECU.
  1. CAN communication system
  2. Main body ECU (cowl side junction block LH)

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs of the CAN communication system (Click here).

    OK:
    CAN communication system DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
  1. Replace the main body ECU.


NEXT


3.RECHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
USE SIMULATION METHOD TO CHECK (Click here)
OK

END (MAIN BODY ECU IS DEFECTIVE)