DTC C1ABA Blind Spot Monitor Slave Module Connection Incorrect |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1ABA | There is an open in the ground circuit (Terminal No. 3) of the blind spot monitor sensor LH for a specified period of time. |
|

| 1.CONFIRM PART NUMBER AND IDENTIFICATION MARK |
Confirm whether the blind spot monitor sensors are installed to the correct side or not.
Check if the part number and identification mark of the blind spot monitor sensor on the vehicle is correct.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BODY GROUND) |
Disconnect the O46 blind spot monitor sensor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O46-3 (LGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O46-3 (LGND) - Body ground | Ignition switch ON | Below 1 V |
|
| ||||
| OK | ||
| ||