Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1ABB    Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

for Preparation Click here


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:
When the blind spot monitor sensor is replaced, this DTC is stored, but it does not indicate a malfunction. After replacing the blind spot monitor sensor, enter test mode to force the blind spot monitor sensor to recognize that axis inspection is complete so that the sensor will stop inappropriately storing this DTC. After that, clear the DTCs.


DTC Code
DTC Detection Condition
Trouble Area
C1ABB
A beam axis inspection has not been performed.
Blind spot monitor sensor RH

INSPECTION PROCEDURE

1.PERFORM BEAM AXIS INSPECTION
  1. Perform beam axis inspection using the intelligent tester (Click here).


NEXT

END