Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1A47    Steering Angle Sensor

for Preparation Click here


DESCRIPTION

The blind spot monitor sensor receives the steering angle signal from the steering angle sensor via CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C1A47
A fail flag is transmitted from the steering angle sensor.
  1. Steering angle sensor
  2. Blind spot monitor sensor RH
  3. Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.REPLACE STEERING ANGLE SENSOR
  1. Replace the steering angle sensor (Click here).


NEXT


3.RECHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.
    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor RH
    B
    DTC is output from the blind spot monitor sensor LH
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH

C
REPLACE BLIND SPOT MONITOR SENSOR LH
A

END (STEERING ANGLE SENSOR IS DEFECTIVE)