Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light Remains ON

for Preparation Click here


DESCRIPTION

If any of the following conditions are detected, the ABS warning light remains on:
  1. The ECU connector is disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open or short in the CAN communication line between the combination meter and the skid control ECU.

HINT:
The intelligent tester cannot be used when there is a malfunction in the skid control ECU.


WIRING DIAGRAM


C179944E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the VSC actuator assembly, perform zero point calibration (Click here).
  2. Make sure the skid control ECU is not in test mode before proceeding.
  3. Before using these procedures, first check other DTCs which may cause the ABS warning light to remain on.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK CONNECTOR CONNECTION CONDITION
  1. Check the skid control ECU connector condition.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND)


    C240470E06
  1. Disconnect the A19 ECU connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A19-8 (IG1) - A19-16 (GND1)
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-16 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester ON.

  1. Select Active Test mode and operate the ABS warning light using the intelligent tester.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Light
    ABS warning light
    Warning light ON/OFF
    Observe combination meter

  1. Check that the ABS warning light turns on and off in the combination meter when using the intelligent tester.

    OK:
    The ABS warning light turns ON and OFF in accordance with the intelligent tester operation.

    HINT:
    When the ABS warning light remains illuminated, an open in the wire harness of the combination meter or abnormalities in the meter circuit should be considered.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)