VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK CONNECTOR CONNECTION CONDITION |
Check the skid control ECU connector condition.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A19 ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-8 (IG1) - A19-16 (GND1) | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-16 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select Active Test mode and operate the ABS warning light using the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| ABS Warning Light | ABS warning light | Warning light ON/OFF | Observe combination meter |
Check that the ABS warning light turns on and off in the combination meter when using the intelligent tester.
|
| ||||
| OK | ||
| ||