WIPER AND WASHER SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester or to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Rear Wiper HI SW Signal | Rear wiper HI switch / ON or OFF | ON: Rear wiper switch in HI position OFF: Rear Wiper switch not in HI position | - |
| Rear Wiper LO SW Signal | Rear wiper LO switch / ON or OFF | ON: Rear wiper switch in LO position OFF: Rear Wiper switch not in LO position | - |
| Rear Washer SW Signal | Rear washer switch / ON or OFF | ON: Rear washer switch on OFF: Rear washer switch off | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Wiper Retracted Position | Rear wiper retracting switch signal / ON or OFF | ON: Rear wiper in retracting position OFF: Rear wiper in other position | - |
| Wiper Reverse Position | Rear wiper reverse position switch signal / ON or OFF | ON: Rear wiper in reverse position OFF: Rear wiper in other position | - |
| Linked Rear Wiper Washer | Washer linkage function / AVAIL or NOT AVL | Customized value can be displayed | This item is only used to display the customize status. |
| Rewipe Function | Washer drip preventive function / AVAIL or NOT AVL | Customized value can be displayed | This item is only used to display the customize status. |
| Back Door P/W Status | Back door power window position / Open or Close | Open: Back door window is open Close: Back door window is closed | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Washer Switch | Washer fluid level warning switch / ON or OFF | ON: Washer jar and tank is empty OFF: Washer jar and tank is full | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester or to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Rear Wiper Washer Motor Relay | Rear Wiper Washer motor operation | ON/OFF | - |
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Rear Wiper Active | Rear Wiper motor operation | STOP/ACTIVE | - |