Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER (REFERENCE)

NOTICE:
  1. When the customer requests a change in a function, first make sure the function(s) can be customized.
  2. Be sure to make note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Customize Setting.

  5. Select the setting by referring to the table below.

    Wiper 
    Display
    Default
    Content
    Setting
    Linked Rear Wiper Washer
    AVAIL
    Function to make the rear wiper run automatically after the washer function is used.
    NOT AVAIL/AVAIL
    Rewipe Function
    AVAIL
    Function to make the rear wiper run once automatically a certain amount of time after the washer function is completed, to prevent the dripping of washing fluid.
    NOT AVAIL/AVAIL