Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Cool Box)
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    E181845E02
  1. Remove the caps from the service valves on the refrigerant line.
    Text in Illustration 
    *1
    Low Pressure Service Valve
    *2
    High Pressure Service Valve

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B161741
  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B161742
  1. Detach the 12 clips and remove the console panel.



4. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


B222976
  1. Move the shift lever to N.

  1. Remove the clip.

  1. Detach the 6 clips and remove the console panel.

  1. Disconnect the connector



5. REMOVE REAR CONSOLE BOX POCKET (w/o Cool Box)


B188221
  1. Remove the rear console box pocket.



6. REMOVE CONSOLE BOX CARPET (w/o Cool Box)


B188222
  1. Remove the console box carpet.



7. REMOVE REAR CONSOLE BOX ASSEMBLY (w/o Cool Box)


B188223
  1. Disconnect the connectors.



    B192330
  1. Remove the 4 bolts and 2 screws.

  1. Detach the 6 claws and remove the rear console box.



8. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY (w/ Cool Box)


    B262023
  1. Remove the 2 bolts and disconnect the air conditioner tube and accessory assembly from the cooling box assembly.

  1. Remove the 2 O-rings from the air conditioner tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



9. REMOVE COOLING BOX TRAY (w/ Cool Box)


    B262024
  1. Remove the cooling box tray.



10. REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)


    B262025
  1. Disconnect the 3 connectors.



    B262026
  1. Remove the 4 bolts.

  1. Remove the 4 No. 1 cool box packings.



    B262027
  1. Detach the 4 clips and claw, and remove the cooling box assembly.



11. REMOVE REAR CONSOLE BOX ASSEMBLY (w/ Cool Box)


    B262028
  1. Disconnect the 2 connectors.



    B262029
  1. Remove the 4 bolts and 2 screws.

  1. Detach the 6 claws and remove the rear console box.



12. REMOVE YAW RATE SENSOR ASSEMBLY



C154452E01

  1. Remove the 2 nuts (labeled A) and sensor.

  1. Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.