QUARTER WINDOW GLASS > INSTALLATION |
| 1. CLEAN QUARTER WINDOW GLASS |
![]() |
Clean the outer circumference of the glass with a non-residue solvent.
| 2. CLEAN VEHICLE BODY |
![]() |
Clean and shape the contact surface of the vehicle body.
Using a knife, cut away any rough adhesive on the contact surface of the vehicle body to ensure the appropriate surface shape.
Clean the contact surface of the vehicle body with a shop rag or piece of cloth saturated with cleaner.
| 3. INSTALL QUARTER WINDOW GLASS |
![]() |
Using a brush, apply Primer M to the exposed part of the vehicle body.
![]() |
Using a brush or sponge, apply Primer G to the edge of the quarter window and contact surface.
| Area | Specified Condition |
| a | 5 mm (0.197 in.) |
| b | 20 mm (0.787 in.) |
| c | 26 mm (1.024 in.) |
![]() |
Apply adhesive.
Cut the tip off the cartridge nozzle, as shown in the illustration.
| Temperature | Usage Time Frame |
| 35°C (95°F) | 15 minutes |
| 20°C (68°F) | 1 hour 40 minutes |
| 5°C (41°F) | 8 hours |
Load the sealer gun with the cartridge.
Apply adhesive to the quarter window as shown in the illustration.
| Area | Specified Condition |
| a | 8 mm (0.315 in.) |
| b | 12 mm (0.472 in.) |
| c | 13 mm (0.512 in.) |
Install the quarter window glass onto the body.
Hold the quarter window glass in place securely with protective tape or the equivalent until the adhesive hardens.
Lightly press the front surface of the glass to ensure a close fit.
![]() |
Using a scraper, remove any excessive or protruding adhesive.
| Temperature | Minimum Time Prior to Driving Vehicle |
| 35°C (95°F) | 1 hour 30 minutes |
| 20°C (68°F) | 5 hours |
| 5°C (41°F) | 24 hours |
| 4. CHECK FOR LEAKAGE AND REPAIR |
After the adhesive has hardened, apply water from the outside of the vehicle. Check that no water leaks into the cabin.
If water leaks into the cabin, allow the water to dry and add adhesive.
Remove the protective tape.
| 5. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY |
![]() |
Attach the 4 clips to install the roof side rail garnish.
| 6. INSTALL ROOF HEADLINING ASSEMBLY (w/ Rear Seat Entertainment System) |
Install the roof headlining assembly (Click here).
| 7. INSTALL ROOF HEADLINING ASSEMBLY (w/o Rear Seat Entertainment System) |
Install the roof headlining assembly (Click here).
| 8. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) |
Install the roof headlining assembly (Click here).
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |