DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | Open in ECM back up power source circuit (1 trip detection logic) |
|

| 1.INSPECT FUSE (EFI NO. 1) |
![]() |
Remove the EFI NO. 1 fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI NO. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (EFI NO. 1 FUSE - ECM, BATTERY) |
![]() |
Check the harness and the connector between the EFI NO. 1 fuse and ECM.
Remove the EFI NO. 1 fuse from the engine room relay block.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI NO. 1 fuse terminal 2 - A27-1 (BATT) | Always | Below 1 Ω |
| EFI NO. 1 fuse terminal 2 or A27-1 (BATT) - Body ground | Always | 10 kΩ or higher |
Check the harness and the connector between the EFI NO. 1 fuse and battery.
Remove the EFI NO. 1 fuse from the engine room relay block.
Disconnect the positive battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery positive (+) terminal - EFI NO. 1 fuse terminal 1 | Always | Below 1 Ω |
| Battery positive (+) terminal or EFI NO. 1 fuse terminal 1- Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check that the battery is not depleted .
|
| ||||
| OK | |
| 4.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 5.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Clear DTCs (Click here).
Turn the ignition switch off.
Turn the intelligent tester off.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Result | Proceed to |
| P0560 is output | A |
| No DTC is output | B |
|
| ||||
| A | ||
| ||