Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Customize Setting / Warning.

  5. Select the setting by referring to the table below.

    Warning 
    Display (Item)
    Default
    Content
    Setting
    Driver Side Seatbelt Warning Buzzer
    ON
    Seat belt warning buzzer ON/OFF setting
    ON: Driver buzzer on
    OFF: Driver buzzer off
    Front Passenger Side Seatbelt Warning Buzzer
    ON
    Seat belt warning buzzer ON/OFF setting
    ON: Passenger buzzer on
    OFF: Passenger buzzer off

    HINT:
    When the buzzer off setting is selected, the buzzer activation while the vehicle is being driven is cancelled. However, the buzzer activation when the ignition switch is turned to ON cannot be cancelled.