AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
Measure the line pressure.
Warm up the ATF (Automatic Transmission Fluid).
Turn the ignition switch off.
Lift the vehicle up.
![]() |
Remove the test plug on the transmission case center right side and connect SST.
Lower the vehicle.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.
Measure the line pressure when the engine is idling.
Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.
In the same manner, perform the test with the shift lever in R.
| Condition | Shift Lever in D | Shift Lever in R |
| Idling | 350 to 430 kPa (3.6 to 4.4 kgf/cm2, 51 to 62 psi) | 540 to 650 kPa (5.5 to 6.6 kgf/cm2, 78 to 94 psi) |
| Stall speed | 1170 to 1340 kPa (11.9 to 13.7 kgf/cm2, 170 to 194 psi) | 1540 to 1850 kPa (15.7 to 17.8 kgf/cm2, 223 to 254 psi) |
| Problem | Possible Cause |
| Measured values at both positions are higher than specified pressure |
|
| Measured values at both positions are lower than specified pressure |
|
| Pressure is low in D position only |
|
| Pressure is low in R position only |
|