DTC P0778 Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0778 | The ECM checks for an open or short in the shift solenoid valve SL2 circuit while driving and shifting gears (1 trip detection logic). Output signal duty ratio equals to 100%.
|
|

| Terminal No. (Symbol) | Tool Setting | Condition | Specified Condition |
| D56-12 (SL2+) - D56-13 (SL2-) | 5 V/DIV., 1 msec./DIV. | Engine is idling | Refer to illustration |

| ECM gear shift command | 1st | 2nd | 3rd | 4th | 5th | 6th |
| Shift solenoid valve SL2 | ON | ON | ON | ON | OFF | OFF |
| 1.INSPECT NO. 2 TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL2) |
![]() |
Disconnect the D42 No. 2 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 (SL2+) - 4 (SL2-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 2 (SL2+) - Body ground | Always | 10 kΩ or higher |
| 4 (SL2-) - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected (No. 2 Transmission Wire) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSMISSION WIRE - ECM) |
![]() |
Disconnect the D56 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-12 (SL2+) - D56-13 (SL2-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| D56-12 (SL2+) - Body ground | Always | 10 kΩ or higher |
| D56-13 (SL2-) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SL2 |
![]() |
Remove the shift solenoid valve SL2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes an operating noise |
| *a | Component without harness connected (Shift Solenoid Valve SL2) |
|
| ||||
| OK | ||
| ||