Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C0278/11    Open or Short Circuit in ABS Solenoid Relay Circuit

for Preparation Click here


DESCRIPTION

The solenoid relay (skid control ECU interior circuit) supplies power to the ABS solenoid and TRC solenoid.
After the ignition switch is turned ON, the solenoid is determined to be normal by the initial check self-diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
This DTC may be set if the voltage supply to the solenoid relay (+BS) falls below the DTC detection threshold due to the battery or alternator outputs being insufficient.

DTC Code
DTC Detection Condition
Trouble Area
C0278/11
When either of following conditions detected:
  1. Malfunction in skid control ECU continues for 0.056 seconds or more.
  2. Voltage supply to solenoid valve stops for 0.056 seconds or more.
  1. ABS2 H-fuse
  2. Harness or connector (+BS circuit)
  3. VSC actuator (skid control ECU)

WIRING DIAGRAM


C152722E08


INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.INSPECT FUSE (ABS2)


    C152723E03
  1. Remove the ABS2 H-fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ABS2 H-fuse
    Always
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND)


    C240470E02
  1. Disconnect the A19 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A19-32 (+BS) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-16 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Check if the same DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)