Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

AIRBAG SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



CHECK MODE (Signal Check): DTC CHECK
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Select Signal Check, and proceed with checking using the intelligent tester.

    NOTICE:
    Select Signal Check from the DTC check screen displayed on the intelligent tester to clear the output DTCs (both present and past).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.