Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit

for Preparation Click here


DESCRIPTION

During VSC operation, the skid control buzzer sounds.
When performing a sensor check in test mode, the buzzer sounds when some of the sensor checks are completed. When a brake pad is overheated, the buzzer sounds as a warning.

WIRING DIAGRAM


C160045E07


INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester ON.

  1. Select the Active Test mode and operate the skid control buzzer using the intelligent tester.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON/OFF
    Buzzer can be heard

  1. Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the intelligent tester.
    Result 
    Result
    Proceed to
    Buzzer does not sound or sounds constantly
    A
    Buzzer sounds/stops
    B



B
REPLACE VSC ACTUATOR ASSEMBLY (Click here)
A


2.INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)


    C107604E32
  1. Disconnect the H5 buzzer connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H5-2 - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


3.INSPECT SKID CONTROL BUZZER


    C140186E04
  1. Disconnect the H5 buzzer connector.

  1. Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.

    OK:
    Skid control buzzer sounds.



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SKID CONTROL BUZZER)


    C240480E01
  1. Disconnect the A19 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-9 (BZ) - H5-1
    Always
    Below 1 Ω
    A19-9 (BZ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND)


    C240470E07
  1. Disconnect the A19 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-16 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)