POWER WINDOW CONTROL SYSTEM > Rear Power Window RH does not Operate with Rear Power Window Switch RH |

| 1.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH - BATTERY) |
![]() |
Disconnect the N3 rear power window regulator switch RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| N3-3 (B) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT REAR POWER WINDOW REGULATOR SWITCH RH |
![]() |
Remove the rear power window regulator switch RH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 (U) - 3 (B) | UP | Below 1 Ω |
| 1 (D) - 2 (SD) | UP | Below 1 Ω |
| 4 (U) - 5 (SU) | OFF | Below 1 Ω |
| 1 (D) - 2 (SD) | OFF | Below 1 Ω |
| 4 (U) - 5 (SU) | DOWN | Below 1 Ω |
| 1 (D) - 3 (B) | DOWN | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW SWITCH RH - REAR POWER WINDOW MOTOR RH) |
![]() |
Disconnect the N3 rear power window regulator switch RH connector.
Disconnect the N4 rear power window regulator motor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N3-1 (D) - N4-1 | Always | Below 1 Ω |
| N3-4 (U) - N4-2 | Always | Below 1 Ω |
| N3-1 (D) - Body ground | Always | 10 kΩ or higher |
| N3-4 (U) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY |
![]() |
Remove the rear power window regulator motor RH (Click here).
Apply battery voltage and check that the motor gear rotates smoothly as follows.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates counterclockwise |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates clockwise |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH - REAR POWER WINDOW SWITCH RH) |
![]() |
Disconnect the M2 power window regulator master switch connector.
Disconnect the N3 rear power window regulator switch RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M2-10 (U) - N3-5 (SU) | Always | Below 1 Ω |
| M2-16 (D) - N3-2 (SD) | Always | Below 1 Ω |
| M2-10 (U) - Body ground | Always | 10 kΩ or higher |
| M2-16 (D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||