POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > IG Power Source Circuit |

| 1.INSPECT FUSE (ECU-IG No. 1) |
![]() |
Remove the ECU-IG No. 1 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY) |
![]() |
Disconnect the H57 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H57-8 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H57-11 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||