Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

DTC    B2621    Communication Interruption

for Preparation Click here


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that they are connected to the network by outputting a specified signal (periodical signal) to the communication bus at regular intervals. The multiplex tilt and telescopic ECU detects the connection of each ECU based on the signal.

DTC Code
Detection Condition
Trouble Area
B2621
Periodical signal from the specified ECU has stopped.
  1. CAN communication system
  2. Main body ECU
  3. Front power seat control switch LH
  4. Combination meter
  5. Multiplex tilt and telescopic ECU

INSPECTION PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check the DTC of the CAN communication system (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.READ VALUE USING INTELLIGENT TESTER (MAIN BODY ECU COMMUNICATION SIGNAL)
  1. Use the Data List to check if the main body ECU communication signal is functioning properly.

    Tilt & Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    J/B
    Communication state of main body ECU signal/OK or Interpt
    OK: Communication is normal
    Interpt: Communication is interrupted
    -

OK:
"OK" is displayed.



NG
REPLACE MAIN BODY ECU
OK


3.READ VALUE USING INTELLIGENT TESTER (FRONT POWER SEAT CONTROL ECU AND SWITCH LH COMMUNICATION SIGNAL)
  1. Use the Data List to check if the front power seat control ECU and switch LH communication signal is functioning properly.

    Tilt & Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Receive from Seat ECU
    Communication state of front power seat control switch LH signal / OK or Interpt
    OK: Communication is normal
    Interpt: Communication is interrupted
    -

OK:
"OK" is displayed.



NG
REPLACE FRONT POWER SEAT SWITCH LH (DRIVER SEAT ECU) (Click here)
OK


4.READ VALUE USING INTELLIGENT TESTER (COMBINATION METER ECU COMMUNICATION SIGNAL)
  1. Use the Data List to check if the combination meter ECU communication signal is functioning properly.

    Tilt & Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Receive from Meter
    Communication state of combination meter signal / OK or Interpt
    OK: Communication is normal
    Interpt: Communication is interrupted
    -

OK:
"OK" is displayed.



NG
REPLACE COMBINATION METER ASSEMBLY (COMBINATION METER ECU) (Click here)
OK

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)