Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER (REFERENCE)

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Utility / Customize / Tilt & Telesco.

  5. Select the setting by referring to the table below.

    Tilt & Telescopic 
    Tester Display
    Default
    Content
    Setting
    Autoaway/Return function
    ON
    ON/OFF of the auto away/return function
    ON/OFF