FUEL TANK > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. REMOVE FUEL TANK CAP |
| 3. REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY |
Remove the 2 bolts, 2 nuts and tank protector.
| 4. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Detach the lock claw by lifting up the cover, as shown in the illustration.
Pinch and pull the main tube connector to disconnect the fuel tank main tube sub-assembly connector from the pipe.
| 5. DISCONNECT FUEL TANK RETURN TUBE |
![]() |
Detach the lock claw by lifting up the cover, as shown in the illustration.
Pinch and pull the return tube connector to disconnect the fuel tank return tube connector from the pipe.
| 6. REMOVE FUEL TANK ASSEMBLY |
![]() |
Disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
![]() |
Pull up the retainer and disconnect the vent line hose.
![]() |
Detach the lock claw by lifting up the cover, as shown in the illustration.
Disconnect the fuel tank breather tube from the fuel tank inlet pipe sub-assembly.
![]() |
Set a mission jack underneath the fuel tank assembly.
Remove the 2 bolts, 2 clips, 2 pins and 2 fuel tank bands.
Slowly lower the mission jack slightly.
![]() |
Disconnect the wire harness clamp from the fuel tank assembly.
Disconnect the fuel pump connector and lower the mission jack.
| 7. REMOVE NO. 1 FUEL TANK HEAT INSULATOR |
![]() |
Disconnect the 6 tubes from the 6 tube clamps.
![]() |
Remove the nut from the heat insulator.
Using needle-nose pliers, remove the 4 clips shown in the illustration and then remove the No. 1 fuel tank heat insulator.
| 8. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() |
Remove the 2 tube joint clips and pull out the 2 fuel tank tubes.
![]() |
Using SST, loosen the retainer.
Remove the retainer.
Remove the fuel suction with pump and gauge tube assembly from the fuel tank.
Remove the gasket from the fuel tank.