Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

DTC    B1000/31    Center Airbag Sensor Assembly Malfunction

for Preparation Click here


DESCRIPTION

The center airbag sensor consists of the airbag sensor, the safing sensor, the drive circuit, the diagnosis circuit, the ignition control, etc.
If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.
DTC B1000/31 is stored when a malfunction is detected in the center airbag sensor.

DTC Code
Detection Condition
Trouble Area
B1000/31
Center airbag sensor malfunction
Center airbag sensor assembly

HINT:
When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code first.


INSPECTION PROCEDURE

1.CHECK CENTER AIRBAG SENSOR
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    OK:
    DTC B1000/31 is not output.

Result 
Result
Proceed to
OK
A
NG (w/ Cool Box)
B
NG (w/o Cool Box)
C


B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

C
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)