Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > PRECAUTION

for Preparation Click here



1.WASHER NOZZLE ADJUSTMENT PRECAUTION
  1. Do not clean or adjust the washer nozzle using objects such as needles or safety pins, because;

    1. The washer nozzle tip is made of resin and could be damaged.

    2. Adjustment is not necessary as the washer nozzle is a spray type.

  2. If the washer nozzle is clogged with substances such as car wax, remove it and clean the nozzle hole with a soft resin brush or similar tool.


2.REAR WIPER AND WASHER OPERATION
  1. When the following conditions are satisfied, rear wiper and washer are driven.

    1. Ignition switch is ON
    2. Back door power window is initialized (Click here).
    3. Back door power window glass is in fully closed condition.
    4. Back door power window regulator switch or tail gate control switch is not operated*.

    HINT:
    *: This condition is for the rear wiper only.