Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the rear seat entertainment system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    3.BASIC INSPECTION
    1. Turn the ignition switch to ACC.

    2. Check whether or not the display appears on the television display assembly.
      Result 
      Result
      Proceed to
      Display appears (w/ Navigation System)
      A
      Display appears (w/o Navigation System)
      B
      Display does not appear
      B



    B.
    Go to step 5
    A


    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTC.

    3. Recheck for DTCs. Based on the DTC output in the first step, try to force output of the navigation system DTC by simulating the operation indicated by the DTC.

      HINT:
      1. If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace problem parts.
      2. Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores past DTCs.
      3. Refer to the detailed description on the diagnostic screen, as necessary (Click here).
      4. Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.

      Result 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.PERFORM CONFIRMATION TEST

        NEXT

        END