THEFT DETERRENT SYSTEM > ECU Power Source Circuit |

| 1.CHECK MAIN BODY ECU (POWER SOURCE) |
![]() |
Disconnect the DA and DB main body ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DA-1 (ALTB) - Body ground | Always | 11 to 14 V |
| DB-13 (ECUB) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BODY GROUND) |
![]() |
Disconnect the DD main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DD-62 (GND1 and GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||