PARK / NEUTRAL POSITION SWITCH > INSTALLATION |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Install the switch to the manual valve shaft.
![]() |
Temporarily install the bolt.
![]() |
Install a new lock washer and the nut.
![]() |
Temporarily install the control shaft lever RH.
![]() |
Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
Remove the control shaft lever RH.
![]() |
Align the groove with the neutral basic line.
Hold the switch in the position described above and tighten the bolt.
![]() |
Using a screwdriver, bend the tabs of the lock washer.
![]() |
Install the transmission control shaft lever RH with the spring washer and nut.
Connect the switch connector.
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Connect the cable with the nut.
| 3. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.
Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.
Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
If the operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 4. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press the lock piece from the back side to release the lock.
![]() |
Check that the adjust case's spring is applying enough tension to the shift control cable. Then press the lock piece to set the lock.
Return the cover of the adjust case to its original position.
Inspect the operation after the adjustment.
| 5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Apply the parking brake and turn the ignition switch to ON.
Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in the other positions.
Check that the back-up light illuminates and the reverse warning buzzer sounds when the shift lever is in R, but does not function in the other positions.
If a malfunction failure is found, check the park/ neutral position switch for continuity.