Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM

OCCUPANT CLASSIFICATION SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK FOR DTC
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to ON and turn the intelligent tester on.

  4. Enter the following menus: Body / Occupant Detection / DTC.

    HINT:
    Refer to intelligent tester operator's manual for further details.


CLEAR DTC
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to ON and turn the intelligent tester on.

  4. Enter the following menus: Body / Occupant Detection / DTC.

  5. Clear the DTCs.

    HINT:
    Refer to intelligent tester operator's manual for further details.