AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit |

| 1.INSPECT FUSES (AMP, ACC) |
Remove the AMP fuse from the engine room junction block.
Remove the ACC fuse from the cowl side junction block LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| AMP fuse | Always | Below 1 Ω |
| ACC fuse |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the I17 and I16 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I16-2 (GND) - Body ground | Always | Below 1 Ω |
| I16-6 (GND2) - Body ground |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I16-1 (+B) - I16-2 (GND) | Always | 11 to 14 V |
| I16-3 (+B2) - I16-2 (GND) | ||
| I17-12 (ACC) - I16-2 (GND) | Ignition switch ACC |
|
| ||||
| OK | ||
| ||