SEAT POSITION SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat) |
Remove the front seat assembly (Click here).
| 3. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat) |
Remove the front seat assembly (Click here).
| 4. REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat) |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
![]() |
Remove the 3 screws.
Detach 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.
Detach the wire harness clamp and disconnect the connector.
| 5. REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat) |
![]() |
Disconnect the connector from the seat position airbag sensor.
Using T30 "TORX" socket wrench, remove the screw and the seat position airbag sensor.
Remove the seat slide position sensor protector from the seat position airbag sensor.
| 6. REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat) |
![]() |
Disconnect the connector from the seat position airbag sensor.
Using "TORX" socket wrench T30, remove the "TORX" screw and the seat position airbag sensor.
Remove the seat slide position sensor protector from the seat position airbag sensor.