DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0500 | While vehicle being driven, no vehicle speed sensor signal transmitted to ECM (2 trip detection logic) |
|

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check whether the operation of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the intelligent tester.
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMBINATION METER ASSEMBLY (+S VOLTAGE) |
![]() |
Disconnect the combination meter connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H37-35 (+S) - Body ground | Ignition switch ON | 4.5 to 5.5 V |
|
| ||||
| OK | |
| 4.INSPECT COMBINATION METER ASSEMBLY (SPD SIGNAL WAVEFORM) |
![]() |
Move the shift lever to N.
Jack up the vehicle.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H37-35 (+S) - Body ground |
| Voltage generated intermittently |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
![]() |
Disconnect the combination meter connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H37-35 (+S) - A27-13 (SPD) | Always | Below 1 Ω |
| H37-35 (+S) or A27-13 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||