DTC P0722 Output Speed Sensor Circuit No Signal |

| DTC Code | DTC Detection Condition | Trouble Area |
| P0722 | All conditions below are detected 5 seconds or more continuously (2 trip detection logic) (a) No signal from speed sensor SP2 is input to ECM while 4 pulses of No. 1 vehicle speed sensor signal are sent (b) Vehicle speed is 9 km/h (5.59 mph) or more (c) Park/neutral position switch is OFF |
|

| Item | Content |
| Terminal No. (Symbol) | D56-101 (SP2+) - D56-100 (SP2-) |
| Tool setting | 2 V/DIV., 20 msec./DIV |
| Condition | Vehicle speed 20 km/h (12 mph) |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (SP2) | Output shaft speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph) (output shaft speed is equal to vehicle speed) | - |
| 1.INSPECT SPEED SENSOR SP2 INSTALLATION |
![]() |
Check the speed sensor SP2 installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR SP2 |
![]() |
Disconnect the D44 speed sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR SP2 - ECM) |
![]() |
Disconnect the D56 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-101 (SP2+) - D56-100 (SP2-) | 20°C (68°F) | 560 to 680 Ω |
| D56-101 (SP2+) - Body ground | Always | 10 kΩ or higher |
| D56-100 (SP2-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||