DTC P0722 Output Speed Sensor Circuit No Signal |

| *1 | Parking Gear (Timing Rotor) | *2 | Clutch Drum (Timing Rotor) |
| *3 | Speed Sensor SP2 | *4 | Speed Sensor NT |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0722 | All conditions are met 5 seconds or more continuously (2 trip detection logic): (a) No signal from speed sensor SP2 is input to the ECM while 4 pulses of the No. 1 vehicle speed sensor signal are sent. (b) Vehicle speed is 9 km/h (5.59 mph) or more. (c) Park/neutral position switch is OFF. |
|

| Terminal No. (Symbol) | Tool Setting | Condition | Specified Condition |
| D56-101 (SP2+) - D56-100 (SP2-) | 2 V/DIV., 20 msec./DIV. | Vehicle speed 20 km/h (12 mph) | Refer to illustration |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (SP2) | Output shaft speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph) (output shaft speed is equal to vehicle speed) | - |
| 1.INSPECT SPEED SENSOR SP2 INSTALLATION |
![]() |
Check the speed sensor SP2 installation.
| *a | CORRECT |
| *b | INCORRECT |
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR SP2 |
![]() |
Disconnect the D44 speed sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
| *a | Component without harness connected (Speed Sensor SP2) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR SP2 - ECM) |
![]() |
Disconnect the D56 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-101 (SP2+) - D56-100 (SP2-) | 20°C (68°F) | 560 to 680 Ω |
| D56-101 (SP2+) - Body ground | Always | 10 kΩ or higher |
| D56-100 (SP2-) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||